P1366 BMW Fault Code

Description:

The Camshaft Position sensor will signal the Engine Control Module when the #1 cylinder is ready for the spark plug to fire (top-dead-center on compression stroke).

The ECM uses the information from this sensor to help calculate fuel delivery and spark timing.

P1366 Code Symptoms :

While fuel economy was increased, acceleration was seriously compromised, and the loss of engine vacuum led to a dangerous loss of braking assist when the P1366 code system was in four-cylinder mode. In addition to these issues, while the company proposed a hydraulically controlled system that could be switched from within the car, the version they implemented had to be manually changed in the engine compartment using hand tools.

Diagnosis And Repairing P1366

P1366 OBD2 may also be triggered by faults earlier down the line. For example, a dirty MAF sensor might be causing the car to overcompensate in its fuel-trim adjustments. As a result, oxygen sensors are likely to report fuel mixture problems.

How to fix P1366 code ?

• Exhaust gas leaks
• Faulty Variable Camshaft Timing (VCT) position solenoid
• Engine Control Module (ECM)
• Foreign matter caught in fuel filler cap

In most cases, the TCM is integrated into a single housing with the BMW PCM. Nevertheless, the section of the module which controls (automatic) transmission function may be powered up separately.

In any case, the TCM is typically powered using switched (only present with the ignition switch in the ON, start, or run position) voltage. This circuit is normally equipped with a fuse, fusible link, and/or a relay. Frequently, the PCM and TCM are powered using the same relay albeit by separate circuits. Access to a reliable vehicle information source will yield necessary details of the TCM power circuit for the specific vehicle in question.